SubNet Mask: 255.255.255.0 or it should match what the main host router is using.(Other 2ndary wireless devices maybe using. 1.# then change the 3rd octet to match, i.e. If your host routers IP address is 192.168. Set a static IP address for the Airport Express under local networking section. NOTE: Tested this configuration with a 1st generation Airport Express (Wireless G only and TPIK).Īirport Device Configuration Using Apples Airport Utilitiesġ. Newer generation models may support Single mode N and AES only configurations. Check Apples support site for generation and feature support information. Older generations do not support N mode or AES only cypher. The wireless mode and Cypher depend on generation of Apple device used. Enable IPv4 Multi-Cast Streams under Advanced Networking. HT20/40 Co-existence enabled for routers that have this feature and WMM Enabled under Advanced Wireless. Mixed G and N modes, WPA2 and Auto Cypher (TPIK and AES), Channel Width - Auto 20/40Mhz, Manual channel 11 or Auto Scan under Setup/Wireless/Manual. On the D-Link router, set the following settings for WiFI and Advanced WiFi and Advanced Networking: Apples Airport Utilities, v5.6 for older generations of Apple devices or v6 for newer generations of devices.Īpple Airport Express, iTunes and Mac Book Pro used for this exampleġ.Apple TV or Apple Airport Extreme or Express or Any Apple device that supports the Airplay feature.Apple Mac PC or Laptop or Windows PC or Laptop.Heres a step by step guide to set up Apples Airplay features using Apple supported Airplay devices connected to D-Link routers.
0 kommentar(er)
